Cisco 3032 - Page 14

Contents
xiv
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Using Interface Configuration Mode 11-8
Procedures for Configuring Interfaces 11-9
Configuring a Range of Interfaces 11-10
Configuring and Using Interface Range Macros 11-11
Using the Internal Ethernet Management Port 11-13
Understanding the Internal Ethernet Management Port 11-13
Supported Features on the Ethernet Management Port 11-15
Layer 3 Routing Configuration Guidelines 11-16
Monitoring the Ethernet Management Port 11-16
TFTP and the Ethernet Management Port 11-17
Configuring Ethernet Interfaces 11-17
Default Ethernet Interface Configuration 11-17
Configuring Interface Speed and Duplex Mode 11-19
Speed and Duplex Configuration Guidelines 11-19
Setting the Interface Speed and Duplex Parameters 11-20
Configuring IEEE 802.3x Flow Control 11-21
Configuring Auto-MDIX on an Interface 11-22
Adding a Description for an Interface 11-23
Configuring Layer 3 Interfaces 11-24
Configuring SVI Autostate Exclude 11-25
Configuring the System MTU 11-26
Monitoring and Maintaining the Interfaces 11-28
Monitoring Interface Status 11-28
Clearing and Resetting Interfaces and Counters 11-29
Shutting Down and Restarting the Interface 11-29
CHAPTER 12 Configuring Smartports Macros 12-1
Understanding Smartports Macros 12-1
Configuring Smartports Macros 12-2
Default Smartports Macro Configuration 12-2
Smartports Macro Configuration Guidelines 12-2
Creating Smartports Macros 12-4
Applying Smartports Macros 12-5
Applying Cisco-Default Smartports Macros 12-6
Displaying Smartports Macros 12-8