Cisco 3032 - Page 16

Contents
xvi
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Configuring the VMPS Client 13-29
Entering the IP Address of the VMPS 13-29
Configuring Dynamic-Access Ports on VMPS Clients 13-30
Reconfirming VLAN Memberships 13-30
Changing the Reconfirmation Interval 13-30
Changing the Retry Count 13-31
Monitoring the VMPS 13-31
Troubleshooting Dynamic-Access Port VLAN Membership 13-32
VMPS Configuration Example 13-32
CHAPTER 14 Configuring VTP 14-1
Understanding VTP 14-1
The VTP Domain 14-2
VTP Modes 14-3
VTP Advertisements 14-4
VTP Version 2 14-4
VTP Version 3 14-5
VTP Pruning 14-6
VTP and Switch Stacks 14-8
Configuring VTP 14-8
Default VTP Configuration 14-8
VTP Configuration Guidelines 14-9
Domain Names 14-9
Passwords 14-10
VTP Version 14-10
Configuration Requirements 14-11
Configuring VTP Mode 14-11
Configuring a VTP Version 3 Password 14-13
Configuring a VTP Version 3 Primary Server 14-14
Enabling the VTP Version 14-15
Enabling VTP Pruning 14-16
Configuring VTP on a Per-Port Basis 14-16
Adding a VTP Client Switch to a VTP Domain 14-17
Monitoring VTP 14-18