33-13
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 33 Configuring SNMP
Configuring SNMP
Note Though visible in the command-line help strings, fru-ctrl, insertion, and removal keywords are not
supported on the nonstacking-capable switch. To enable the sending of SNMP inform notifications, use
the snmp-server enable traps global configuration command combined with the snmp-server host
host-addr informs global configuration command.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in Table 33-5.
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
port-security Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
Note When you configure a trap by using the notification type
port-security, configure the port security trap first, and then
configure the port security trap rate:
• snmp-server enable traps port-security
• snmp-server enable traps port-security trap-rate rate
rtr Generates a trap for the SNMP Response Time Reporter (RTR).
snmp Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
storm-control Generates a trap for SNMP storm-control. You can also set a maximum trap
rate per minute. The range is from 0 to 1000; the default is 0 (no limit is
imposed; a trap is sent at every occurrence).
stpx Generates SNMP STP Extended MIB traps.
syslog Generates SNMP syslog traps.
tty Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership Generates a trap for SNMP VLAN membership changes.
vlancreate Generates SNMP VLAN created traps.
vlandelete Generates SNMP VLAN deleted traps.
vtp Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 33-5 Switch Notification Types (continued)
Notification Type
Keyword Description
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
snmp-server engineID remote
ip-address engineid-string
Specify the engine ID for the remote host.
To Next Page
Loading...
