Cisco 3110 - Page 91

2-75
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-3-RESOURCE_INTERNAL: Internal Error in resource allocation.
Explanation An internal software error has occurred.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
Error Message QOSMGR-3-VMRSEQ_INVALID: Internal Error Invalid VMR sequence.
Explanation An internal software error has occurred.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
Error Message QOSMGR-4-ACTION_NOT_SUPPORTED: Action is not supported in policymap
[chars].
Explanation An action other than the set, trust, and police policy-map class configuration
commands was configured in a policy map. This is a hardware limitation. [chars] is the policy-map
name.
Recommended Action Configure only the supported actions of set, trust, and police when in
policy-map class configuration mode.
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Explanation An unsupported match class-map configuration command was configured in a policy
map and attached to an egress interface, or more than one match class-map command was
configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action Reconfigure the class map or the policy map. Use only the match ip dscp
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.