2-76
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.
Explanation The command to configure a QoS setting failed. This is possibly due to lack of hardware
resources. [chars] is the description of the command.
Recommended Action Check if any other messages indicate resource failure. If other messages
indicate that the hardware resources are exceeded, retry the command with a smaller configuration.
Find out more about the error by using the show tech-support privileged EXEC command and by
copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about
these online tools and about contacting IBM, see the
“Error Message Traceback Reports” section on
page 1-6.
Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for
policymap [chars].
Explanation The policy-map configuration has exceeded the limitation of the hardware. You
configured more QoS ACL entries than the number specified in the Switch Database Management
(SDM) template. [chars] is the policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS
ACLs.
Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap
[chars].
Explanation An unsupported match type was entered. Only the access-group acl-index-or-name, ip
dscp dscp-list, and ip precedence ip-precedence-list match types are supported with the match
class-map configuration command. [chars] is the class-map name.
Recommended Action Reconfigure the class map; use only the match access-group, match ip dscp,
and match ip precedence class-map configuration commands within the class map.
Error Message QOSMGR-4-NOT_SUPPORTED: Action ’[chars]’ is not supported for a
policymap attached to output side.
Explanation A set or trust policy-map class configuration command was configured in a policy map
and attached to an egress interface. A warning message is logged, and the actions do not take effect.
This is a hardware limitation. [chars] is either the set or trust action.
Recommended Action Do not configure a set or trust policy-map class configuration command in a
policy map and attach it to an egress interface. These policy-map actions are supported only on
ingress interfaces.
To Next Page
Loading...
Need help?
General