Contents
xiv
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Configuring Backup Controllers 7-41
Using the GUI to Configure Backup Controllers 7-42
Using the CLI to Configure Backup Controllers 7-44
Configuring Failover Priority for Access Points 7-46
Using the GUI to Configure Failover Priority for Access Points 7-46
Using the CLI to Configure Failover Priority for Access Points 7-48
Using the CLI to View Failover Priority Settings 7-48
Configuring Country Codes 7-49
Guidelines for Configuring Multiple Country Codes 7-49
Using the GUI to Configure Country Codes 7-50
Using the CLI to Configure Country Codes 7-52
Migrating Access Points from the -J Regulatory Domain to the -U Regulatory Domain 7-55
Guidelines for Migration 7-56
Migrating Access Points to the -U Regulatory Domain 7-56
Using the W56 Band in Japan 7-58
Dynamic Frequency Selection 7-58
Optimizing RFID Tracking on Access Points 7-59
Using the GUI to Optimize RFID Tracking on Access Points 7-59
Using the CLI to Optimize RFID Tracking on Access Points 7-61
Configuring Probe Request Forwarding 7-62
Retrieving the Unique Device Identifier on Controllers and Access Points 7-63
Using the GUI to Retrieve the Unique Device Identifier on Controllers and Access Points 7-63
Using the CLI to Retrieve the Unique Device Identifier on Controllers and Access Points 7-64
Performing a Link Test 7-64
Using the GUI to Perform a Link Test 7-65
Using the CLI to Perform a Link Test 7-67
Configuring Link Latency 7-67
Using the GUI to Configure Link Latency 7-68
Using the CLI to Configure Link Latency 7-69
Configuring Power over Ethernet 7-70
Using the GUI to Configure Power over Ethernet 7-71
Using the CLI to Configure Power over Ethernet 7-73
Configuring Flashing LEDs 7-74
Viewing Clients 7-74
Using the GUI to View Clients 7-74
Using the CLI to View Clients 7-78
To Next Page
Loading...
Need help?
General
