Cisco 4400 Series User Manual

D-28
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Appendix D Troubleshooting
Troubleshooting CCXv5 Client Devices
Figure D-7 Profile Details Page
This page shows the client profile details, including the SSID, power save mode, radio channel, data
rates, and 802.11 security settings.
Using the CLI to Configure Client Reporting
Using the controller CLI, follow these steps to configure client reporting.
Step 1 To send a request to the client to send its profiles, enter this command:
config client ccx get-profiles client_mac_address
Step 2 To send a request to the client to send its current operating parameters, enter this command:
config client ccx get-operating-parameters client_mac_address
Step 3 To send a request to the client to send the manufacturer’s information, enter this command:
config client ccx get-manufacturer-info client_mac_address
Step 4 To send a request to the client to send its capability information, enter this command:
config client ccx get-client-capability client_mac_address
Step 5 To clear the client reporting information, enter this command:
config client ccx clear-reports client_mac_address

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing