Cisco 4400 Series User Manual

4-73
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Cisco Discovery Protocol
Figure 4-29 All APs > Details for (Advanced) Page
d.
Check the Cisco Discovery Protocol check box to enable CDP on this access point or uncheck
it to disable this feature. The default value is enabled.
e. Click Apply to commit your changes.
• To enable or disable CDP on all access points currently associated to the controller, follow these
steps:
a. Click Wireless > Access Points > Global Configuration to open the Global Configuration
page.
b. Check the CDP State check box to enable CDP on all access points associated to the controller
or uncheck it to disable CDP on all access points. The default value is checked.
c. Click Apply to commit your changes.
Step 9 Click Save Configuration to save your changes.
Using the GUI to View Cisco Discovery Protocol Information
Follow these steps to view CDP information using the controller GUI.
Step 1 To see a list of all CDP neighbors on all interfaces, click Monitor > CDP > Interface Neighbors. The
CDP > Interface Neighbors page appears (see Figure 4-30).

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing