Cisco 4400 Series User Manual

7-78
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Viewing Clients
This page shows the following information:
• The general properties of the client
• The security settings of the client
• The QoS properties of the client
• Client statistics
• The properties of the access point to which the client is associated
Using the CLI to View Clients
Use these CLI commands to view client information.
• To see the clients associated to a specific access point, enter this command:
show client ap {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
MAC Address AP Id Status WLAN Id Authenticated
----------------- ------ ------------- --------- -------------
00:13:ce:cc:8e:b8 1 Associated 1 No
• To see a summary of the clients associated to the controller’s access points, enter this command:
show client summary
Information similar to the following appears:
Number of Clients................................ 6
MAC Address AP Name Status WLAN Auth Protocol Port Wired
----------------- ----------------- ------------- ---- ---- -------- ---- -----
00:13:ce:cc:8e:b8 Maria-1242 Probing N/A No 802.11a 1 No
00:40:96:a9:a0:a9 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:ac:44:13 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:b1:fe:06 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:b1:fe:09 CJ-AP1 Probing N/A No 802.11a 1 No
• To see detailed information for a specific client, enter this command:
show client detail client_mac
Information similar to the following appears:
Client MAC Address............................... 00:40:96:b2:a3:44
Client Username ................................. N/A
AP MAC Address................................... 00:18:74:c7:c0:90
Client State..................................... Associated
Wireless LAN Id.................................. 1
BSSID............................................ 00:18:74:c7:c0:9f
Channel.......................................... 56
IP Address....................................... 192.168.10.28
Association Id................................... 1
Authentication Algorithm......................... Open System
Reason Code...................................... 0
Status Code...................................... 0
Session Timeout.................................. 0
Client CCX version............................... 5
Client E2E version............................... No E2E support

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing