Name: Cisco 4400 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

5-65

Cisco Wireless LAN Controller Configuration Guide

OL-17037-01

Chapter 5 Configuring Security Solutions

Configuring and Applying Access Control Lists

Using the CLI to Apply Access Control Lists

Follow these steps to apply ACLs using the controller CLI.

Step 1 Perform any of the following:

• To apply an ACL to a management, AP-manager, or dynamic interface, enter this command:

config interface acl {management | ap-manager | dynamic_interface_name} acl_name

Note To see the ACL that is applied to an interface, enter show interface detailed {management

| ap-manager | dynamic_interface_name}. To remove an ACL that is applied to an interface,

enter config interface acl {management | ap-manager | dynamic_interface_name} none.

See Chapter 3 for more information on configuring controller interfaces.

• To apply an ACL to the data path, enter this command:

config acl apply acl_name

• To apply an ACL to the controller CPU to restrict the type of traffic (wired, wireless, or both)

reaching the CPU, enter this command:

config acl cpu acl_name {wired | wireless | both}

Note To see the ACL that is applied to the controller CPU, enter show acl cpu. To remove the

ACL that is applied to the controller CPU, enter config acl cpu none.

• To apply an ACL to a WLAN, enter this command:

config wlan acl wlan_id acl_name

Note To see the ACL that is applied to a WLAN, enter show wlan wlan_id. To remove the ACL

that is applied to a WLAN, enter config wlan acl wlan_id none.

• To apply a preauthentication ACL to a WLAN, enter this command:

config wlan security web-auth acl wlan_id acl_name

See Chapter 6 for more information on configuring WLANs.

Step 2 To save your settings, enter this command:

save config

Questions and Answers:

Need help?

Do you have a question about the Cisco 4400 Series and is the answer not in the manual?

Cisco 4400 Series Specifications

General