Contents
xix
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Using the CLI to Debug CCX Radio Management Issues 11-41
Configuring Pico Cell Mode 11-41
Guidelines for Using Pico Cell Mode 11-42
Using the GUI to Configure Pico Cell Mode 11-42
Using the CLI to Configure Pico Cell Mode 11-44
Using the CLI to Debug Pico Cell Mode Issues 11-45
CHAPTER
12 Configuring Mobility GroupsWireless Device Access 12-1
Overview of Mobility 12-2
Overview of Mobility Groups 12-5
Determining When to Include Controllers in a Mobility Group 12-7
Messaging among Mobility Groups 12-7
Using Mobility Groups with NAT Devices 12-8
Configuring Mobility Groups 12-9
Prerequisites 12-9
Using the GUI to Configure Mobility Groups 12-11
Using the CLI to Configure Mobility Groups 12-14
Viewing Mobility Group Statistics 12-16
Using the GUI to View Mobility Group Statistics 12-16
Using the CLI to View Mobility Group Statistics 12-19
Configuring Auto-Anchor Mobility 12-20
Guidelines for Using Auto-Anchor Mobility 12-21
Using the GUI to Configure Auto-Anchor Mobility 12-21
Using the CLI to Configure Auto-Anchor Mobility 12-23
WLAN Mobility Security Values 12-25
Using Symmetric Mobility Tunneling 12-26
Running Mobility Ping Tests 12-28
CHAPTER
13 Configuring Hybrid REAPWireless Device Access 13-1
Overview of Hybrid REAP 13-2
Hybrid-REAP Authentication Process 13-2
Hybrid REAP Guidelines 13-4
Configuring Hybrid REAP 13-5
Configuring the Switch at the Remote Site 13-5
Configuring the Controller for Hybrid REAP 13-6
Using the GUI to Configure the Controller for Hybrid REAP 13-7
Using the CLI to Configure the Controller for Hybrid REAP 13-11
Configuring an Access Point for Hybrid REAP 13-11
To Next Page
Loading...
Need help?
General
