Cisco 4400 Series User Manual

5-72
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring Management Frame Protection
Conditional Web Redirect............... Disabled
Auto Anchor............................ Enabled
H-REAP Local Switching................. Disabled
Infrastructure MFP protection.......... Enabled
Client MFP............................. Required
...
3. To see the current MFP configuration for a particular access point, enter this command:
show ap config general AP_name
Information similar to the following appears:
Cisco AP Identifier.............................. 0
Cisco AP Name.................................... ap:52:c5:c0
AP Regulatory Domain............................. 80211bg: -N 80211a: -N
Switch Port Number .............................. 1
MAC Address...................................... 00:0b:85:52:c5:c0
IP Address Configuration......................... Static IP assigned
IP Address....................................... 10.67.73.33
IP NetMask....................................... 255.255.255.192
...
AP Mode ......................................... Local
Remote AP Debug ................................. Disabled
S/W Version .................................... 4.0.2.0
Boot Version ................................... 2.1.78.0
Mini IOS Version ................................ --
Stats Reporting Period .......................... 180
LED State........................................ Enabled
ILP Pre Standard Switch.......................... Disabled
ILP Power Injector............................... Disabled
Number Of Slots.................................. 2
AP Model......................................... AP1020
AP Serial Number................................. WCN09260057
AP Certificate Type.............................. Manufacture Installed
Management Frame Protection Validation .......... Enabled
4. To see whether client MFP is enabled for a specific client, enter this command:
show client detail client_mac
Client MAC Address............................... 00:14:1c:ed:34:72
...
Policy Type...................................... WPA2
Authentication Key Management.................... PSK
Encryption Cipher................................ CCMP (AES)
Management Frame Protection...................... Yes
...
5. To see MFP statistics for the controller, enter this command:
show wps mfp statistics
Information similar to the following appears:
Note This report contains no data unless an active attack is in progress. Examples of various error
types are shown for illustration only. This table is cleared every 5 minutes when the data is
forwarded to any network management stations.

Cisco 4400 Series Specifications

General

Brand	Cisco
Model	4400 Series
Category	Controller
Language	English