6-48
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 5 To assign an access point to an access point group, enter this command:
config ap group-name group_name Cisco_AP
Note To remove an access point from an access point group, re-enter this command and assign the
access point to another group.
Step 6 To save your changes, enter this command:
save config
Using the CLI to View Access Point Groups
Use these CLI commands to view information about or to troubleshoot access point groups.
1. To see a list of all access point groups on the controller, enter this command:
show wlan apgroups
Information similar to the following appears:
Site Name........................................ AP2
Site Description................................. Access Point 2
WLAN ID Interface Network Admission Control
------- ----------- --------------------------
1 management Disabled
2 management Disabled
3 management Disabled
4 management Disabled
9 management Disabled
10 management Disabled
11 management Disabled
12 management Disabled
13 management Disabled
14 management Disabled
15 management Disabled
16 management Disabled
18 management Disabled
AP Name Slots AP Model Ethernet MAC Location Port Country Priority GroupName
------- ---- -------------- ----------------- ------- ---- ------- -------- ---------
AP1242 2 AP1242AG-A-K9 00:14:1c:ed:23:9a default 1 US 1 AP2
...
2. To see the BSSIDs for each WLAN assigned to an access point group, enter this command:
show ap wlan {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
Site Name........................................ AP3
Site Description................................. Access Point 3
WLAN ID Interface BSSID
------- ------------ -------------------
10 management 00:14:1b:58:14:df
To Next Page
Loading...
Need help?
General
