7-76
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Viewing Clients
Figure 7-28 Search Clients Page
b.
Check one or more of the following check boxes to specify the criteria used when displaying clients:
• MAC Address—Enter a client MAC address.
Note When you enable the MAC Address filter, the other filters are disabled automatically.
When you enable any of the other filters, the MAC Address filter is disabled
automatically.
• AP Name—Enter the name of an access point.
• WLAN Profile—Enter the name of a WLAN.
• Status—Check the Associated, Authenticated, Excluded, Idle, and/or Probing check boxes.
• Radio Type—Choose 802.11a, 802.11b, 802.11g, 802.11n, or Mobile.
• WGB—Shows WGB clients associated to the controller’s access points.
c. Click Apply to commit your changes. The Current Filter parameter at the top of the Clients page
shows the filters that are currently applied.
Note If you want to remove the filters and display the entire client list, click Show All.
Step 3 To view detailed information for a specific client, click the MAC address of the client. The Clients >
Detail page appears (see Figure 7-29).
To Next Page
Loading...
Need help?
General
