Cisco 4400 Series User Manual

11-24
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Configuring RRM
• monitor—Shows the Cisco radio monitoring.
Default 802.11a AP monitoring
802.11a Monitor Mode........................... enable
802.11a Monitor Channels....................... Country channels
802.11a AP Coverage Interval................... 180 seconds
802.11a AP Load Interval....................... 60 seconds
802.11a AP Noise Interval...................... 180 seconds
802.11a AP Signal Strength Interval......... 60 seconds
• profile {global | Cisco_AP}—Shows the access point performance profiles.
Default 802.11a AP performance profiles
802.11a Global Interference threshold.......... 10%
802.11a Global noise threshold................. -70 dBm
802.11a Global RF utilization threshold........ 80%
802.11a Global throughput threshold............ 1000000 bps
802.11a Global clients threshold............ 12 clients
• receiver—Shows the 802.11a or 802.11b/g receiver configuration and statistics.
802.11a Advanced Receiver Settings
RxStart : Signal Threshold..................... 15
RxStart : Signal Jump Threshold................ 5
RxStart : Preamble Power Threshold............. 2
RxRestart: Signal Jump Status................... Enabled
RxRestart: Signal Jump Threshold................ 10
TxStomp : Low RSSI Status...................... Enabled
TxStomp : Low RSSI Threshold................... 30
TxStomp : Wrong BSSID Status................... Enabled
TxStomp : Wrong BSSID Data Only Status......... Enabled
RxAbort : Raw Power Drop Status................ Disabled
RxAbort : Raw Power Drop Threshold............. 10
RxAbort : Low RSSI Status...................... Disabled
RxAbort : Low RSSI Threshold................... 0
RxAbort : Wrong BSSID Status................... Disabled
RxAbort : Wrong BSSID Data Only Status......... Disabled
--------------------------------------------....
pico-cell-V2 parameters in dbm units:...........
RxSensitivity: Min,Max,Current RxSense Thres.... 0,0,0
CCA Threshold: Min,Max,Current Clear Channel.... 0,0,0
Tx Pwr: Min,Max,Current Transmit Power for A.... 0,0,0
--------------------------------------------....
• summary—Shows the configuration and statistics of the 802.11a or 802.11b/g access points
AP Name Channel TxPower Level
----------------------------- ----------- ----------------
AP1250 (36, 40) 1
• txpower—Shows the transmit power assignment configuration and statistics.
Automatic Transmit Power Assignment
Transmit Power Assignment Mode................. AUTO
Transmit Power Update Interval................. 600 seconds
Transmit Power Threshold....................... -65 dBm
Transmit Power Neighbor Count.................. 3 APs
Transmit Power Update Contribution............. SNI.
Transmit Power Assignment Leader............... 00:0b:85:43:dd:c0
Last Run....................................... 360 seconds ago

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing