11-38
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Configuring CCX Radio Management Features
Figure 11-13 802.11a Global Parameters Page
Step 2
Under CCX Location Measurement, check the Mode check box to globally enable CCX radio
management. This parameter causes the access points connected to this controller to issue broadcast
radio measurement requests to clients running CCX v2 or higher. The default value is disabled (or
unchecked).
Step 3 If you checked the Mode check box in the previous step, enter a value in the Interval field to specify how
often the access points are to issue the broadcast radio measurement requests.
Range: 60 to 32400 seconds
Default: 60 seconds
Step 4 Click Apply to commit your changes.
Step 5 Click Save Configuration to save your settings.
Step 6 Follow the instructions in Step 2 of the “Using the CLI to Configure CCX Radio Management” section
below to enable access point customization.
Note To enable CCX radio management for a particular access point, you must enable access point
customization, which can be done only through the controller CLI.
Step 7 If desired, repeat this procedure for the other radio band (802.11a or 802.11b/g).
To Next Page
Loading...
Need help?
General
