Cisco 4400 Series User Manual

11-40
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Configuring CCX Radio Management Features
3. To see the status of radio measurement requests for a particular access point, enter this command:
show ap ccx rm Cisco_AP status
Information similar to the following appears:
A Radio
Beacon Request................................. Enabled
Channel Load Request........................... Enabled
Frame Request.................................. Disabled
Noise Histogram Request........................ Disabled
Path Loss Request.............................. Disabled
Interval....................................... 60
Iteration...................................... 5
B Radio
Beacon Request................................. Disabled
Channel Load Request........................... Enabled
Frame Request.................................. Disabled
Noise Histogram Request........................ Enabled
Path Loss Request.............................. Disabled
Interval....................................... 60
Iteration................................... 5
4. To see the status of radio measurement requests for a particular client, enter this command:
show client ccx rm client_mac status
Information similar to the following appears:
Client Mac Address............................... 00:40:96:ae:53:b4
Beacon Request................................... Enabled
Channel Load Request............................. Disabled
Frame Request.................................... Disabled
Noise Histogram Request.......................... Disabled
Path Loss Request................................ Disabled
Interval......................................... 5
Iteration........................................ 3
5. To see radio measurement reports for a particular client, enter these commands:
• show client ccx rm client_mac report beacon—Shows the beacon report for the specified
client.
• show client ccx rm client_mac report chan-load—Shows the channel-load report for the
specified client.
• show client ccx rm client_mac report noise-hist—Shows the noise-histogram report for the
specified client.
• show client ccx rm client_mac report frame—Shows the frame report for the specified client.
6. To see the clients configured for location calibration, enter this command:
show client location-calibration summary
7. To see the RSSI reported for both antennas on each access point that heard the client, enter this
command:
show client detail client_mac

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing