Cisco 4400 Series

12-29
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 12 Configuring Mobility GroupsWireless Device Access
Running Mobility Ping Tests
2. To test the mobility EoIP data packet communication between two controllers, enter this command:
eping mobility_peer_IP_address
The mobility_peer_IP_address parameter must be the IP address of a controller that belongs to the
mobility list.
3. To troubleshoot your controller for mobility ping, enter these commands:
config logging buffered debugging
show logging
To troubleshoot your controller for mobility ping over UDP, enter this command to display the
mobility control packet:
debug mobility handoff enable
Note Cisco recommends using an ethereal trace capture when troubleshooting.