13-23
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 13 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid-REAP Groups
i. To specify the number of seconds for the PAC to remain viable, enter this command:
config hreap group group_name radius ap pac-timeout timeout
where timeout is a value between 2 and 4095 seconds (inclusive) or 0. A value of 0, which the default
value, disables the PAC timeout.
Step 5 To save your changes, enter this command:
save config
Step 6 To see the current list of hybrid-REAP groups, enter this command:
show hreap group summary
Information similar to the following appears:
HREAP Group Summary: Count 2
Group Name # Aps
Group 1 1
Group 2 1
Step 7 To see the details for a specific hybrid-REAP group, enter this command:
show hreap group detail group_name
Information similar to the following appears:
Number of Ap's in Group: 3
00:1d:45:12:f2:24 AP1240.EW3.f224 Joined
00:1d:45:12:f7:12 AP1240.10.f712 Joined
00:1d:a1:ed:9f:84 AP1131.23.9f84 Joined
Group Radius Servers Settings:
Primary Server Index............................ Disabled
Secondary Server Index.......................... Disabled
Group Radius AP Settings:
AP RADIUS server............ Enabled
EAP-FAST Auth............... Enabled
LEAP Auth................... Enabled
Server Key Auto Generated... No
Server Key.................. <hidden>
Authority ID................ 436973636f0000000000000000000000
Authority Info.............. Cisco A_ID
PAC Timeout................. 0
Number of User's in Group: 20
1cisco 2cisco
3cisco 4cisco
cisco test1
test10 test11
test12 test13
test14 test15
test2 test3
test4 test5
test6 test7
test8 test9
To Next Page
Loading...
Need help?
General
