Cisco 700 series Configuration Guide

Using CHAP 4-7
Remote Cisco 765 Command Summary
Remote Cisco 765 Command Summary
Following is the command summary to configure the remote Cisco 765 series router for IP
static routing with PAP authentication:
set switch 5ess
set
1 dir directory_number
set 2 dir directory_number
set system 765
set multidestination on
set ppp multi on
set ppp authentication in pap
set ppp authentication out pap
cd lan
set ip address
192.168.147.9
set ip netmask
255.255.255.248
set ip routing on
set ip rip update periodic
set ip rip receive v2
set ip rip version 2
set user
4500
set ip route destination 0.0.0.0 gateway 172.16.125.1 propagate on
set ip address
172.16.125.7
set ip netmask
255.255.255.0
set ip routing on
set ip framing none
set ppp clientname
765
set ppp password client
set ppp password host
set number
5558011
set bridging off
set timeout
360
set active
reboot
For detailed information regarding the commands listed here, refer to the Cisco 700 Series
Router Command Reference.

Cisco 700 series Specifications

General

Wireless	No
Compression	No
WAN Ports	1
Weight	0.48 kg
Power Supply	External
Category	Network Router