EasyManuals Logo

Cisco 700 series Configuration Guide

Cisco 700 series
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Multilink PPP Encapsulation
Cisco700 Series Router Configuration Guide
4-14
Multilink PPP Encapsulation
Cisco 700 series routers implement multilink PPP, which is available in Release 11.0(3) or
later of Cisco IOS software. You can disable multilink PPP in the following two
environments:
You are connecting your Cisco 700 series router to a router running a Cisco IOS release
prior to 11.0(3).
You are connecting your Cisco 700 series router to a router running Cisco IOS Release
11.0(3) or later, and you have not configured multilink PPP on that router running Cisco
IOS.
Use the set ppp multilink command at the system level to disable multilink PPP, as
follows:
766> set ppp multilink off
Dynamic Routing Protocols
Cisco 700 series routers implement RIP Versions 1 and 2 and demand RIP. Demand RIP is
not implemented in Cisco IOS software. If you are connecting your router to a router
running Cisco IOS software, and you want to use a dynamic routing protocol, you must
disable demand RIP.
Use one of the following set ip rip update commands to disable demand RIP:
766> set ip rip update periodic / snapshot
or
766> set ip rip update none
Note Setting the IP RIP update to periodic maintains the connection indefinitely. This
might be a concern if it is not necessary to maintain the line 24 hours a day, 7 days a week;
you are paying for connection time that you are not using.

Table of Contents

Other manuals for Cisco 700 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 700 series and is the answer not in the manual?

Cisco 700 series Specifications

General IconGeneral
WirelessNo
CompressionNo
WAN Ports1
Weight0.48 kg
Power SupplyExternal
CategoryNetwork Router

Related product manuals