Cisco 700 series Configuration Guide

PAT with IPCP Single-Destination Negotiation Example
Cisco700 Series Router Configuration Guide
5-10
Cisco 765 Series Router Commands
Following are the commands for configuring the remote Cisco 765 series router for PAT
with IPCP single-destination negotiation with a Cisco 4500 router:
set system 765
set ip pat po ftp 10.0.0.2
cd lan
set ip address
10.0.0.1
set ip netmask 255.0.0.0
set ip routing on
set user
4500
set active
set 1 number
phone_number
set 2 number
phone_number
set ip routing on
set ip rip version 2
set ip rip receive v2
set ip pat on
reboot
For detailed information regarding the commands listed here, refer to the Cisco 700 Series
Router Command Reference.
Verify the Configuration
When a demand call is made, you can use the show ip config all and show ip route all
commands to see the IPCP negotiation address.
You can use the show ip pat command to see the services returned by PAT.

Cisco 700 series Specifications

General

Wireless	No
Compression	No
WAN Ports	1
Weight	0.48 kg
Power Supply	External
Category	Network Router