Cisco 700 series - Page 86

Cisco 700 Series Router Configuration GuideIndex 4
PPP 3-11
configuration example
routing IP and IPX on-demand 3-14
IP and IPX routing 3-14
IPCP negotiation 5-5
multilink encapsulation, interoperability 4-14
supported protocol 1-1
private IP addresses 5-3
profile-level parameters 2-1
profiles
active 2-2, 2-6
changing a profile name 2-6
creating 2-5
definition 3-2
deleting 2-6
displaying configurations 2-5
inactive 2-2, 2-6
on-demand 2-2
parameters 2-2
permanent 2-4
Internal 2-4
LAN 2-4
Standard 2-4
redefined values indicator 2-5
removing parameters 2-5
system mode parameters 2-3
user-defined 3-10
using with the routers 2-1 to 2-7
protocols supported 1-1
Q
quick reference viii
R
release notes for Cisco IOS 700 software viii
Remote CAPI 6-3
configuration 6-4
configuration example 6-4
TCP port 6-4
Remote CAPI, supported protocol 1-2
Remote Common Application Programmers Interface
See RCAPI
removing profile parameters 2-5
reset user command 2-6
RIP
dynamic routing protocols 4-14
PAT enabled 5-3
supported protocol
router manuals viii
routing
configuration example
bridging 3-7
central site 3-11
routing a Cisco 700 series router 3-9
routing IP and IPX on-demand 3-14
routing to an ISP 3-9
Routing Information Protocol
See RIP
S
SAP, supported protocol 1-1
secret, CHAP 3-4
Service Advertisement Protocol
See SAP
set autodetection command 3-5
set default command 3-4
set ip framing command 5-4
set ip rip update command 4-14
set ppp multilink command 4-14
set profile user command 2-6
set switch command 3-6
set user command 2-3
show commands, defined 2-5
show configuration command 3-3