Cisco 7609 - Configuring IP Multicast Layer 3 Switching; Understanding How IP Multicast Layer 3 Switching Works

Contents
xviii
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Setting a Password for a Router and Cache Engines 35-10
Verifying and Monitoring WCCP Configuration Settings 35-11
WCCP Configuration Examples 35-11
Changing the Version of WCCP on a Router Example 35-12
Performing a General WCCPv2 Configuration Example 35-12
Running a Web Cache Service Example 35-12
Running a Reverse Proxy Service Example 35-13
Registering a Router to a Multicast Address Example 35-13
Using Access Lists Example 35-13
Setting a Password for a Router and Cache Engines Example 35-14
Verifying WCCP Settings Example 35-14
CHAPTER 36 Configuring SNMP IfIndex Persistence 36-1
Understanding SNMP IfIndex Persistence 36-1
Configuring SNMP IfIndex Persistence 36-1
Enabling and Disabling SNMP IfIndex Persistence Globally 36-2
Enabling and Disabling SNMP IfIndex Persistence on Specific Interfaces 36-2
Configuration Examples 36-3
CHAPTER 37 Configuring the Switch Fabric Module 37-1
Understanding How the Switch Fabric Module Works 37-1
Switch Fabric Module Overview 37-1
Switch Fabric Module Slots 37-2
Switch Fabric Redundancy 37-2
Forwarding Decisions for Layer 3-Switched Traffic 37-2
Switching Modes 37-2
Configuring the Switch Fabric Module 37-3
Configuring the Switching Mode 37-3
Configuring Fabric-Required Mode 37-4
Configuring an LCD Message 37-5
Monitoring the Switch Fabric Module 37-5
Displaying the Module Information 37-5
Displaying the Switch Fabric Module Redundancy Status 37-6
Displaying Fabric Channel Switching Modes 37-6
Displaying the Fabric Status 37-7
Displaying the Fabric Utilization 37-7
Displaying Fabric Errors 37-7