Cisco 7609 User Manual

6-4
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 6 Configuring Interfaces
Configuring a Range of Interfaces
Configuring a Range of Interfaces
The interface-range configuration mode allows you to configure multiple interfaces with the same
configuration parameters. After you enter the interface-range configuration mode, all command
parameters you enter are attributed to all interfaces within that range until you exit out of the
interface-range configuration mode.
To configure a range of interfaces with the same configuration, perform this task:
When configuring a range of interfaces, note the following syntax information:
• The space before the dash is required.
• You can enter up to five comma-separated ranges.
• You are not required to enter spaces before or after the comma.
• You must add a space between the interface numbers and the dash when using the interface range
command. For example, interface range fastethernet 1 - 5 is valid syntax; interface range
fastethernet 1-5 is invalid.
• With releases earlier than Release 12.1(14)E, the interface range command supports these interface
keywords:
– ethernet
– fastethernet
– gigabitethernet
– tengigabitethernet
• With Release 12.1(14)E and later releases, the interface range command supports these additional
interface keywords:
– pos
– loopback
– tunnel
• With Release 12.1(14)E and later releases, you can use the no interface range command to delete
VLAN interfaces.
• With releases earlier than Release 12.1(14)E, you cannot use the no keyword with the range
keyword to delete VLAN interfaces.
• With Release 12.1(14)E and later releases, you can use the interface range command to create
VLAN interfaces.
• With releases earlier than Release 12.1(14)E, you cannot use the interface range command to create
VLAN interfaces: the interface range command is supported only with VLAN interfaces that have
been configured with the interface vlan command. You can enter the show running-configuration
command to display the configured VLAN interfaces.
Command Purpose
Router(config)# interface range
{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]}
| {type slot/port - port [, type slot/port - port]} |
{macro_name [, macro_name]}}
Selects the range of interfaces to be configured.
Router(config)# no interface range
{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]}
| {macro_name [, macro_name]}}
Selects the range of VLAN interfaces to remove.

Cisco 7609 Specifications

General

Chassis Slots	9
Switch Fabric Capacity	720 Gbps
Power Supply Options	AC or DC
Product Type	Router
Form Factor	Rack-mountable
Supported Line Cards	Various Cisco 7600 Series line cards
Operating System	Cisco IOS
Management	CLI, SNMP
Forwarding Performance	400 Mpps
Maximum Power Consumption	4000 Watts
Redundancy	Yes
Interfaces/Ports	Various, depending on line cards installed