CHAPTER
1-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
1
Product Overview
The Cisco IOS on the Cisco 7600 Series Router product supports the following hardware and software:
• Supervisor Engine 2, Policy Feature Card 2 (PFC2), and Multilayer Switch Feature Card 2
(MSFC2); and in Catalyst 6500 series switches:
–
Switch Fabric Module
–
Fabric-enabled switching modules
–
Fabric-enabled switching modules with a distributed forwarding card (DFC)
• Supervisor Engine 1, PFC, and MSFC or MSFC2
• All Layer 2 and Layer 3 configuration from the same user interface
• Except for VLANs, Layer 2 and Layer 3 configuration is stored in a standard IOS configuration file
Refer to the Release Notes for Cisco IOS on Catalyst 6500 Series Switches and Cisco 7600 Series Router
publication for complete information about the chassis, modules, and software features supported by the
Cisco 7600 series routers:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/ol_2310.htm
The Cisco IOS on the Cisco 7600 Series Router product supports configuration using:
• CLI—See Chapter 2, “Command-Line Interfaces”
• SNMP—Refer to the IOS Configuration Fundamentals Configuration Guide and Command
Reference at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm
• IOS web browser interface—Refer to “Using the Cisco Web Browser” in the IOS Configuration
Fundamentals Configuration Guide and Command Reference at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm
• Embedded CiscoView—See the “Configuring Embedded CiscoView Support” section on page 1-1.
Configuring Embedded CiscoView Support
These sections describe the Embedded CiscoView support available with Release 12.1(20)E and later
releases:
• Understanding Embedded CiscoView, page 1-2
• Installing and Configuring Embedded CiscoView, page 1-2
• Displaying Embedded CiscoView Information, page 1-3
To Next Page
Loading...
Need help?
General
