Cisco 7609 - Configuring Local SPAN and RSPAN; Understanding How Local SPAN and RSPAN Work

2-2
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 2 Command-Line Interfaces
Accessing the CLI
To make a console connection, perform this task:
After making a console connection, you see this display:
Press Return for Console prompt
Router> enable
Password:
Router#
Accessing the CLI through Telnet
Note Before you can make a Telnet connection to the router, you must configure an IP address (see the
“Configuring IP Routing and Addresses” section on page 12-2).
The router supports up to eight simultaneous Telnet sessions. Telnet sessions disconnect automatically
after remaining idle for the period specified with the exec-timeout command.
To make a Telnet connection to the router, perform this task:
Command Purpose
Step 1
Press Return. Brings up the prompt.
Step 2
Router> enable
Initiates enable mode enable.
Step 3
Password: password
Router#
Completes enable mode enable.
Step 4
Router# quit
Exits the session when finished.
Command Purpose
Step 1
telnet {hostname | ip_addr}
Makes a Telnet connection from the remote host, to the
router you want to access.
Step 2
Password: password
Router#
Initiates authentication.
Note If no password has been configured, press
Return.
Step 3
Router> enable
Initiates enable mode enable.
Step 4
Password: password
Router#
Completes enable mode enable.
Step 5
Router# quit
Exits the session when finished.