Cisco 7609 User Manual

CHAPTER
3-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
3
Configuring the Cisco 7600 Series Router for the
First Time
This chapter contains information about how to initially configure the Cisco 7600 series router, which
supplements the administration information and procedures in these publications:
• Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_c/index.htm
• Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.1, at
this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_r/index.htm
Note For complete syntax and usage information for the commands used in this chapter, refer to the
Cisco 7600 Series Router Cisco IOS Command Reference publication and the Release 12.1 publications
at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/index.htm
This chapter consists of these sections:
• Default Configuration, page 3-1
• Configuring the Cisco 7600 Series Router, page 3-2
• Protecting Access to Privileged EXEC Commands, page 3-15
• Recovering a Lost Enable Password, page 3-19
• Modifying the Supervisor Engine Startup Configuration, page 3-20
Default Configuration
Table 3-1 shows the default configuration.

Cisco 7609 Specifications

General

Chassis Slots	9
Switch Fabric Capacity	720 Gbps
Power Supply Options	AC or DC
Product Type	Router
Form Factor	Rack-mountable
Supported Line Cards	Various Cisco 7600 Series line cards
Operating System	Cisco IOS
Management	CLI, SNMP
Forwarding Performance	400 Mpps
Maximum Power Consumption	4000 Watts
Redundancy	Yes
Interfaces/Ports	Various, depending on line cards installed