Cisco 7609 - Page 300

20-10
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 20 Configuring IPX Unicast Layer 3 Switching on Supervisor Engine 1
Displaying IPX MLS Information
Displaying IPX MLS Cache Entries for a Specific Destination Address
To display IPX MLS cache entries for a specific destination IPX address, perform this task:
This example shows how to display IPX MLS entries for a specific destination address:
Router# show mls ipx destination 1.2.2.2
DstNet-DstNode SrcNet DstVlan-DstMac Pkts Bytes
-----------------------------------------------------------------------
SrcDstPorts SrcDstEncap Age LastSeen
----------------------------------------
Number of Entries Found = 0
Router#
Displaying IPX MLS Cache Entries for a Specific Source Address
To display IPX MLS cache entries for a specific source network address, perform this task:
Note This task should be performed with IPX flow in destination-source mode. For more information, see the
“Flow Mask Modes” section on page 20-3.
This example shows how to display IPX MLS entries for a specific source IPX address:
Router# show mls ipx source 1.2.2.2
DstNet-DstNode SrcNet DstVlan-DstMac Pkts Bytes
-----------------------------------------------------------------------
SrcDstPorts SrcDstEncap Age LastSeen
----------------------------------------
Number of Entries Found = 0
Router#
Command Purpose
Router# show mls ipx [destination ipx_addr]
Displays IPX MLS entries for a specific
destination address (net_address.node_address).
Command Purpose
Router# show mls ipx source ipx_address
Displays IPX MLS entries for a specific source
network address (net_address).