EasyManuals Logo

Cisco 7609 User Manual

Cisco 7609
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #470 background imageLoading...
Page #470 background image
32-72
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 32 Configuring PFC QoS
Configuring PFC QoS
Enabling PFC QoS Statistics Data Export for a Named Aggregate Policer
To enable PFC QoS statistics data export for a named aggregate policer, perform this task:
This example shows how to enable PFC QoS statistics data export for an aggregate policer named
aggr1M and verify the configuration:
Router# configure terminal
Router(config)# mls qos statistics-export aggregate-policer aggr1M
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 300 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
Router#
When enabled for a named aggregate policer, PFC QoS statistics data export contains the following
fields, separated by the delimiter character:
Export type (3 for an aggregate policer)
Aggregate policer name
Direction (in)
PFC or DFC slot number
Number of in-profile packets
Number of packets that exceed the CIR
Number of packets that exceed the PIR
Time stamp
Command Purpose
Step 1
Router(config)# mls qos statistics-export
aggregate-policer aggregate_policer_name
Enables PFC QoS statistics data export for a named
aggregate policer.
Router(config)# no mls qos statistics-export
aggregate-policer aggregate_policer_name
Disables PFC QoS statistics data export for a named
aggregate policer.
Step 2
Router(config)# end
Exits configuration mode.
Step 3
Router# show mls qos statistics-export info
Verifies the configuration.

Table of Contents

Other manuals for Cisco 7609

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7609 and is the answer not in the manual?

Cisco 7609 Specifications

General IconGeneral
Chassis Slots9
Switch Fabric Capacity720 Gbps
Power Supply OptionsAC or DC
Product TypeRouter
Form FactorRack-mountable
Supported Line CardsVarious Cisco 7600 Series line cards
Operating SystemCisco IOS
ManagementCLI, SNMP
Forwarding Performance400 Mpps
Maximum Power Consumption4000 Watts
RedundancyYes
Interfaces/PortsVarious, depending on line cards installed

Related product manuals