Index
IN-5
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
DFC restriction, see CSCdt27074 in the Release Notes
interface port-channel
command example
13-7
interface port-channel (command) 13-7
lacp system-priority
command example
13-10
Layer 2
configuring
13-8
load balancing
configuring
13-11
understanding 13-5
modes 13-3
PAgP
Understanding
13-3
port-channel interfaces 13-5
port-channel load-balance
command
13-10, 13-11
command example 13-11
STP 13-5
understanding 13-1
EtherChannel Guard
See STP EtherChannel Guard
Ethernet
setting port duplex
6-15
examples
configuration
interface
3-8 to 3-9
software configuration register 3-21 to 3-24
configuring global parameters 3-3
extended range VLANs 9-2
See VLANs
Extensible Authentication Protocol over LAN
25-1
F
fabric switching mode
See switch fabric module
fastethernet
6-2
fiber-optic, detecting unidirectional links 31-1
filters
protocol
See protocol filtering
filters, NDE
clearing
33-17
destination host filter, specifying 33-16
destination TCP/UDP port, specifying 33-15
overview 33-6
protocol 33-16
source host and destination TCP/UDP port 33-16
firewall 23-4
Flash memory
configuration process
3-25
configuring router to boot from 3-25
loading system image from 3-24
security precautions 3-25
write protection 3-25
flow control 6-14
flow masks
IP MLS
destination-ip
19-3, 33-2
destination-source-ip 33-2
interface-destination-source-ip 33-2
ip-flow 19-3
ip-full 33-3
ip-interface-full 33-3
source-destination-ip 19-3
IP MMLS and 18-3
IPX MLS
destination
20-3
destination-source 20-3
IPX MLS entries and 20-3
minimum 19-8, 20-8, 33-9
modes 20-3
overview 19-3, 20-3, 33-2
flows
IP MLS
19-2
IP MMLS
completely and partially switched
18-4
To Next Page
Loading...
Need help?
General
