Index
IN-15
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
displaying supervisor engine configuration 4-4
EHSA 4-1
redundancy (RPR+) 5-1
configuring 5-6
configuring supervisor engine 5-5
displaying supervisor engine configuration 5-8
redundancy command 5-6, 5-7
route processor redundancy plus 5-2
redundancy command 4-3
related documentation xxiii
reload command 3-23
reserved-range VLANs
See VLANs
rewrite, packet
CEF
17-2
IP MLS 19-4
IP MMLS 18-3
IPX MLS 20-3
RGMP 22-1
overview 22-1
packet types 22-2
RIF cache monitoring 6-18
rommon command 3-24
ROM monitor
boot process and
3-20
CLI 2-6
root bridge, STP 15-25
root guard
See STP root guard
route processor redundancy
See redundancy (RPR+)
router, multicast
21-12
router-port group management protocol
See RGMP
routing table, multicast
18-16
RPF
failure
18-5
multicast 18-2
non-RPF multicast 18-5
unicast 23-19
RPR+
See redundancy (RPR+)
RSTP
15-15
port roles 15-13
port states 15-14
S
SAID 9-6
sample configuration 3-2 to 3-10
Sampled NetFlow
description
33-6
saving the configuration file 3-11
scheduling
see QoS
secondary VLANs
10-2
secure ports, configuring 26-1
security
configuring
23-1, 24-1
security, port 26-1
security precautions with Flash memory card 3-25
serial interfaces
clearing
6-19
synchronous
maintaining
6-19
service-policy command 32-38
service-policy input command 32-49
set power redundancy enable/disable command 38-2
setup command 3-2
shortcuts, Layer 3
See IP MLS, IP MMLS, or IPX MLS
show boot command
3-26
show bootvar command 3-27
show catalyst6000 chassis-mac-address command 15-3
show cdp command 30-2, 30-3
show cdp entry command 30-3
show cdp interface command 30-3
show cdp neighbors command 30-3
To Next Page
Loading...
Need help?
General
