Phone Configuration for Monitoring Other Phones,
on page 162
Added a new topic replacing the existing Busy Lamp
Field Configuration on a Monitoring Phone topic.
Configure the Phone to Monitor Multiple Users' Lines,
on page 163
Added a new topic replacing the existing Configure
the Phone to Monitor Multiple Users' Lines topic.
Enable P-Early-Media Support, on page 191Added a new task on how to enable early media
support
Profile Authentication, on page 192
Specify the Profile Authentication Type, on page 193
Added topics replacing the “Set up Profile Account”
topic to support the enhancements in profile
authentication
DND and Call Forwarding Status Sync, on page 196
Enable Feature Key Sync, on page 197
Enable Call Forwarding Status Sync via XSI Service,
on page 197
Enable DND Status Sync via XSI Service, on page
198
XSI Line Service, on page 289
Added new fields and topics to support the feature of
DND and call forwarding status sync
Include a Device Identifier in Uploaded Syslog
Messages, on page 205
Added a new topic about including a device identifier
in uploaded syslog messages.
Report a Phone Problem Remotely, on page 185
PRT Status, on page 185
Added new fields and a new task on how to remotely
report phone problems.
Optional Network Configuration, on page 228
Added the Syslog Identifier field.
Configuration Profile, on page 242
Replaced the Profile Account Enable parameter with
the Profile Authentication Type field
Updated the description of the Profile Rule parameter.
Upload Configuration Options, on page 249
Updated Report Rule and added new parameters:
Report to Server, periodic Upload to Server, and
Upload Delay on Local Change.
Line Key, on page 266
Updated the description for the Extension field.
LDAP, on page 273
Updated the description of the First Name Filter and
Last Name Filter fields.
Voice > Ext (n) > General, on page 278Example XML parameter configuration is added for
the Line Enable parameter.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
2
New and Changed Information
New and Changed for Firmware Release 11.2(3)
To Next Page
Loading...
Need help?
General
