Cisco 7940G

4-11
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SIP)
OL-15499-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
SIP Configuration Menu
Line Configuration Menu
The Line Configuration menu displays information that relate to the configurable parameters for the
lines in your phone. To access this menu, choose the appropriate Line x Settings option from the SIP
Configuration menu. For more information, see the
“SIP Configuration Menu” section on page 4-9.
Start Media Port Displays the start Real-Time Transport Protocol (RTP)
range for media.
1. Scroll to the Start Media Port
option, press the Edit softkey, and
then enter the desired value.
2. Press the Accept softkey.
3. Press the Save softkey.
End Media Port Displays the end Real-Time Transport Protocol (RTP)
range for media.
1. Scroll to the End Media Port
option, press the Edit softkey, and
then enter the desired value.
2. Press the Accept softkey.
3. Press the Save softkey.
Backup Proxy Not applicable in a Cisco Unified Communications
Manager environment.
—
Backup Proxy Port Not applicable in a Cisco Unified Communications
Manager environment.
—
Emergency Proxy Not applicable in a Cisco Unified Communications
Manager environment.
—
Emergency Proxy Port Not applicable in a Cisco Unified Communications
Manager environment.
—
Outbound Proxy Not applicable in a Cisco Unified Communications
Manager environment.
—
Outbound Proxy Port Not applicable in a Cisco Unified Communications
Manager environment.
—
NAT Enabled Displays if Network Address Translation (NAT) is enabled. 1. Scroll to the NAT Enabled option
and then press the Yes or the No
softkey to change the setting.
2. Press the Save softkey.
NAT Address Displays the WAN IP address of the NAT or firewall server. 1. Scroll to the NAT Address option,
press the Edit softkey, and then
enter the desired IP Address.
2. Press the Accept softkey.
3. Press the Save softkey.
Call Statistics Displays if call statistics are enabled on the phone. 1. Scroll to the Call Statistics option
and then press the Yes or the No
softkey to change the setting.
2. Press the Save softkey.
Table 4-5 SIP Configuration Menu Options (continued)
Option Description To Change