Table 5: Access Control Parameters
Description and Default ValueParameter Name
Enables or disables access to the phone web interface. Set this parameter to Yes to
allow users or administrators to access the phone web interface. Otherwise, set it to
No. When set to No, the phone web interface isn't accessible.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Enable_Web_Server ua="na">Yes</Enable_Web_Server>
• In the phone web interface, set to Yes to allow the access.
Allowed values: Yes|No
Default: Yes.
Enable Web Server
Allows or blocks the access to the phone administration pages:
http://<phone_IP>/admin
When set to No, access to the pages is allowed even with the correct password.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Enable_Web_Admin_Access ua="na">Yes</Enable_Web_Admin_Access>
• In the phone web interface, set this parameter to Yes to allow the access.
Otherwise, set it to No.
Allowed values: Yes|No
Default: Yes
Enable Web Admin
Access
Allows you to set or change the password for accessing the phone administration web
pages.
The Admin Password parameter is only available on the phone administration web
page.
A valid password must contain 4 to 127 characters from three out of the four types:
capital letter, small letter, number, and special character.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Admin_Password ua="na">P0ssw0rd_tes89</Admin_Password>
• In the phone web interface, enter the password for administrator access.
Default: Empty
Admin Password
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
106
Cisco IP Phone Configuration
Access Control Parameters
To Next Page
Loading...
Need help?
General
