Call Forward
To enable call forwarding, you can enable the feature in two places: on the Voice tab and the User tab of the
phone web page.
Enable Call Forwarding on Voice Tab
Perform this task if you want to enable call forward for a user.
You can also configure the parameters in the phone configuration file with XML(cfg.xml) code. To configure
each parameter, see the syntax of the string in the Parameters for Enable Call Forward on Voice Tab, on page
240 table.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Phone.
Step 2 Under Supplementary Services, configure the parameters as described in the Parameters for Enable Call
Forward on Voice Tab, on page 240 table.
Step 3 Click Submit All Changes.
Related Topics
DND and Call Forwarding Status Sync, on page 207
Enable Feature Key Sync, on page 206
Enable Call Forwarding Status Sync via XSI Service, on page 208
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
239
Cisco IP Phone Configuration
Call Forward
To Next Page
Loading...
Need help?
General
