Step 2 Under Supplementary Services, configure the parameters as defined in the Parameters for Enable Call
Transfer, on page 238 table.
Step 3 Click Submit All Changes.
Parameters for Enable Call Transfer
The following table defines the function and usage of Enable Call Transfer parameters in the Supplementary
Services section under the Phone tab in the phone web interface. It also defines the syntax of the string that
is added in the phone configuration file with XML(cfg.xml) code to configure a parameter.
Table 45: Parameters for Enable Call Transfer
DescriptionParameter
Attended call transfer service. The user answers the
call before transferring it.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Attn_Transfer_Serv
ua="na">Yes</Attn_Transfer_Serv>
• In the phone web page, select Yes to enable the
transfer service. Select No to disable it.
Options: Yes and No
Default: Yes
Attn Transfer Serv
Blind call transfer service. The user transfers the call
without speaking to the caller.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Blind_Transfer_Serv
ua="na">Yes</Blind_Transfer_Serv>
• In the phone web page, select Yes to enable the
transfer service. Select No to disable it.
Options: Yes and No
Default: Yes
Blind Transfer Serv
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
238
Cisco IP Phone Configuration
Parameters for Enable Call Transfer
To Next Page
Loading...
Need help?
General
