Parameters for XSI Phone Service
The following table defines the function and usage of the XSI directory parameters in the XSI Phone Service
section under the Voice > Phone tab in the phone web interface. It also defines the syntax of the string that
is added in the phone configuration file (cfg.xml) with XML code to configure a parameter.
Table 62: Parameters for XSI Phone Service
DescriptionParameter
Enter the name of the server; for example,
xsi.iop1.broadworks.net
XSI Host Server uses http protocol by
default. To enable XSI over HTTPS, you
can specify https:// in the server.
Note
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<XSI_Host_Server
ua="na">https://xsi.iop1.broadworks.net</XSI_Host_Server>
• In the phone web interface, enter the XSI server
to use.
Default: Empty
XSI Host Server
Determines the XSI authentication type. Select Login
Credentials to authenticate access with XSI id and
password. Select SIP Credentials to authenticate
access with the register user ID and password of the
SIP account registered on the phone.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<XSI_Authentication_Type ua="na">SIP
Credentials</XSI_Authentication_Type>
• In the phone web interface, specify the
authentication type for XSI service.
Valid values: Login credentials|SIP Credentials
Default: Login Credentials
XSI Authentication Type
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
303
Cisco IP Phone Configuration
Parameters for XSI Phone Service
To Next Page
Loading...
Need help?
General
