DescriptionField
Defines the interval (in seconds) that the phone reports its configuration to the provisioning
servers.
This field is used only when Report to Server is set to Periodically.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<periodic_upload_to_server ua="na">3600</periodic_upload_to_server>
• In the phone web interface, specify the interval in seconds.
Allowed values: An integer ranging between 600 and 259200
Default: 3600
Periodic
Upload to
Server:
Defines the delay (in seconds) that the phone waits after a change is made, and then reports
the configuration.
This field is used only when Report to Server is set to On Local Change.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Upload_Delay_On_Local_Change ua="na">60</Upload_Delay_On_Local_Change>
• In the phone web interface, specify the delay in seconds.
Allowed values: An integer ranging between 10 and 900
Default: 60
Upload Delay
On Local
Change:
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
115
Cisco IP Phone Configuration
Parameters for Reporting the Phone Configuration to the Server
To Next Page
Loading...
Need help?
General
