DescriptionParameter Name
Allows you to enter a voice quality report name.
Your report name cannot begin with a:
• hyphen (-)
• semicolon (;)
• space
In the phone XML configuration file (cfg.xml), enter
a string in this format:
<Voice_Quality_Report_Group_1_
ua="na">test-group-1</Voice_Quality_Report_Group_1_>
Default parameter = empty (The report will use the
canonical name in the form of
identifier@ipAddress.)
Voice Quality Report Group
Allows you to determine when the phones send SIP
Publish messages.
If you have properly configured the Voice Quality
Report Address, the SIP Publish messages can be
sent:
• When the call has ended or is placed on hold.
• Periodically, when you enter an interval in
seconds for this parameter. Example: 20 for
20-second intervals. )
In the phone XML configuration file (cfg.xml), enter
a string in this format:
<VQ_Report_Interval_1_
ua="na">20</VQ_Report_Interval_1_>
Default parameter = 0 (no periodic SIP Publish
Message)
Voice Quality Report Interval
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
283
Cisco IP Phone Configuration
VQM SIP Publish Message Parameters
To Next Page
Loading...
Need help?
General
