syntax of the string that is added in the phone configuration file with XML(cfg.xml) code to configure a
parameter.
Table 82: Parameters for Control Timer Values (sec)
DescriptionParameter
Delay after far end hangs up before reorder (busy)
tone is played.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Reorder_Delay
ua="na">255</Reorder_Delay>
• In the phone web page, set a value in seconds
ranges from 0-255 secs.
0 = plays immediately, inf = never plays. Set to 255
to return the phone immediately to on-hook status and
to not play the tone.
Allowed values: 0–255 seconds
Default: 255
Reorder Delay
Long timeout between entering digits when dialing.
The interdigit timer values are used as defaults when
dialing. The Interdigit_Long_Timer is used after any
one digit, if all valid matching sequences in the dial
plan are incomplete as dialed.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Interdigit_Long_Timer
ua="na">10</Interdigit_Long_Timer>
• In the phone web page, set a value in seconds
ranges from 0-64 seconds.
Allowed values: 0–64 seconds
Default: 10
Interdigit Long Timer
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
402
Cisco IP Phone Installation
Parameters for Control Timer Values (sec)
To Next Page
Loading...
Need help?
General
