You can place the multicharger on a work surface or mount it on a wall with the wall mount kit. You can also
secure the multicharger with a standard laptop cable lock.
The LED beside the battery slot shows the charging status. When the battery is charging, the LED lights red.
When the battery is charged, the LED lights green.
Battery slot LEDs can take several minutes to indicate that the battery is fully charged. If you move a
fully-charged battery to another slot, the LED might initially light red before it turns green.
Do not use chargers in a Potentially Explosive Atmosphere.
Do not charge the phone if it is wet.
Caution
Set Up the Multicharger
The power jack is on the right side of the multicharger.
Procedure
Step 1
Plug the jack end of the power cord into the multicharger.
Step 2
Plug the other end of the power cord into the power adapter.
Step 3
Plug the power adapter into the electrical outlet.
Step 4
Place the multicharger on a stable work surface.
Install the Multicharger Wall Mount Kit
The wall mount kit comes with the following components:
•
bracket
Cisco Wireless IP Phone 8821 and 8821-EX User Guide
83
Accessories
Set Up the Multicharger