Cisco 8821

•
package with 5 screws and 5 self-tapping wall anchors
Before You Begin
You need the following tools:
•
Drill and a 0.25 inch drill bit
•
Pencil
•
Level
•
Philips #1 and #2 screwdrivers
You need the power cable and power adapter.
Procedure
Step 1
Determine the location for the bracket. The bottom right corner of the bracket must be less than 50 inches
(127 cm) from an electrical outlet.
Step 2
Mount the wall bracket.
a) Hold the bracket on the wall, as shown in the diagram.
b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.
c) Install the anchors, using the drill and drill bit.
d) Screw the bracket to the wall.
Step 3
Locate the post holders in the multicharger.
Step 4
Hold the multicharger so that the post holders are in front of the posts on the bracket, press the multicharger
towards the wall, and then push the multicharger down so that the posts seat into the holder.
Cisco Wireless IP Phone 8821 and 8821-EX User Guide
84
Accessories
Install the Multicharger Wall Mount Kit