Cisco 8832 - Auto Provision Your Phone with Short Activation Code; Install the Wired Expansion Microphones

The phone completes the onboarding process automatically.
Step 3 If an error message displays, enter the code again or contact your administrator for a new code.
Auto Provision Your Phone with Short Activation Code
After your phone boots up, you see a welcome screen where you can enter the activation code. If you don't
have the activation code, contact your administrator.
Before you begin
Your administrator provides your activation code:
Procedure
Step 1 Press pound (#), and enter your activation code in the field that is provided on the Welcome screen.
Step 2 Press Continue.
The phone completes the provisioning process automatically.
Step 3 If an error message displays, enter the code again or contact your administrator.
Install the Wired Expansion Microphones
The phone supports an optional kit with two wired expansion microphones. You can extend the microphones
up to 7 feet (2.13m) from the phone. For best results, place the microphones between 3 feet (0.91 m) and 7
feet (2.1 m) away from the phone.
Procedure
Step 1 Plug the end of the microphone cable into the port on the side of the phone.
Step 2 Extend the microphone cable to the desired position.
The following figure shows installation of a wired expansion microphone.
Cisco IP Conference Phone 8832 Multiplatform Phone User Guide
10
Your Phone
Auto Provision Your Phone with Short Activation Code