2-23
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Installing or Removing the Mounting Plate Latch
Caution The 1250 series power injectors and 1250 series DC power modules are designed for an open-air
environment. To avoid damaging the units, you must not bind together multiple power injectors or power
modules.
Installing or Removing the Mounting Plate Latch
The mounting plate latch is located on the bottom of the access point (seeFigure 2-16).
Figure 2-16 Mounting Plate Latch
Installing the Mounting Plate Latch
Follow these steps to install the mounting plate latch:
Step 1 Place the bottom of access point facing up and locate the two screw holes for the mounting plate latch
(see Figure 2-16).
Step 2 Place the mounting plate latch over the two screw holes.
Step 3 Screw two 3/16 in (0.476 cm) 4x40 screws into the screw holes.
Removing the Mounting Plate Latch
Follow these steps to remove the mounting plate latch:
Step 1 Place the bottom of access point facing up and locate the two screw holes for the mounting plate latch
(see Figure 2-16).
Step 2 Unscrew the two mounting plate screws and remove the mounting plate latch.
1 Bottom of access point 3 Mounting plate latch
2 Mounting plate latch screws
To Next Page
Loading...
