2-27
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Securing the Access Point
Securing the Access Point
There are two ways to secure your access point:
• Securing the access point to the mounting plate with a padlock
• Using a security cable to secure the access point
Securing the Access Point to the Mounting Plate
You can use a padlock to secure the access point to the mounting plate to prevent removal of the radio
modules when the mounting plate is screwed to a wall or ceiling. Known compatible padlocks are Master
Lock models 120T or 121T. Figure 2-19 shows the padlock hole and the mounting plate latch from the
bottom side of the access point for clarity.
Note The mounting plate latch must be installed on the access point to enable attachment of the mounting
plate. The access point is shipped with the mounting plate latch and the mounting plate installed.
Figure 2-19 Security Padlock Hole as Viewed From the Bottom of the Access Point
1 Access point 3 Security padlock hole
2 Mounting plate latch
To Next Page
Loading...
