EasyManuals Logo

Cisco AIR-AP1252AG-A-K9 User Manual

Cisco AIR-AP1252AG-A-K9
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
B-2
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Appendix B Declarations of Conformity and Regulatory Information
Manufacturers Federal Communication Commission Declaration of Conformity Statement
Manufacturers Federal Communication Commission
Declaration of Conformity Statement
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this
frequency when using the integrated antennas. Any changes or modification to the product not expressly
approved by Cisco could void the user’s authority to operate this device.
Models Certification Numbers
AIR-RM1252A-A-K9 LDK102061
AIR-RM1252G-A-K9 LDK102062
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AIR-AP1252AG-A-K9 and is the answer not in the manual?

Cisco AIR-AP1252AG-A-K9 Specifications

General IconGeneral
ModelAIR-AP1252AG-A-K9
Device TypeWireless Access Point
Frequency Bands2.4 GHz, 5 GHz
Wireless Standards802.11a/b/g
MIMO TechnologyYes
Power over Ethernet (PoE)Yes
Weight2.2 lbs
Data Transfer RateUp to 54 Mbps
RAM64 MB
Flash Memory16 MB
Encryption AlgorithmAES, TKIP
Maximum Data Rate54 Mbps
Antenna TypeExternal
Data Link ProtocolEthernet
Compliant StandardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g
Authentication MethodWPA, WPA2
Operating Temperature0 to 50 °C
Storage Temperature-20 to 70 °C
Humidity10 to 90% non-condensing
Security FeaturesWPA, WPA2
MountingWall or ceiling mount

Related product manuals