2-26
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Installing the Access Point to the Mounting Plate
Mounting Plate Attached to a Surface
Note Your access point must have the mounting bracket latch attached to the bottom of the unit.
When the mounting plate is attached to a surface, follow these steps to install the access point to the
mounting plate:
Step 1 Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
inserted and both module latches are in the locked position (see Figure 2-24).
Step 2 Locate the the mounting plate latch opening on your mounting plate (see Figure 2-2).
Step 3 Position the end of the access point with the mounting plate latch (see Figure 2-16) towards the end of
the mounting plate with the latch opening.
Step 4 To assist in aligning the access point to the mounting plate, place the access point on the mounting plate
and align the access point side (with the security cable key slot) with the outline on the mounting plate
(see Figure 2-18).
Figure 2-18 Align Access Point to Mounting Plate Marking
Step 5 Slowly slide the access point over the outline on the mounting plate until the mounting plate latch clicks.
Step 6 Visually verify that the four access point foot pins are securely held by the mounting plate slots.
1 Outline on mounting plate 2 Security cable key slot side of access point
To Next Page
Loading...
