3-21
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
Reloading the Access Point Image
Step 3 At the prompt, enter the administrator username and password. The default username is Cisco and the
default password is Cisco. The username and password are case sensitive. The Summary Status page
displays.
Step 4 Click the System Software tab and then click Software Upgrade. The HTTP Upgrade page displays.
Step 5 Click the Browse button to locate the access point image file (such as c1250-k9w7-tar.124-10b.JA.tar )
on your PC.
Step 6 Click Upload.
For additional information, click the Help icon on the Software Upgrade page.
Browser TFTP Interface
The TFTP interface allows you to use a TFTP server on a network device to load the access point image
file. Follow these instructions to use a TFTP server:
Step 1 Open your Internet browser.
Note When using the access point browser interface, you should disable your browser pop-up blocker.
Step 2 Enter the access point’s IP address in the browser address line and press Enter. An Enter Network
Password page displays.
Step 3 At the prompt, enter the administrator username and password. The default username is Cisco and the
default password is Cisco. The username and password are case sensitive. The Summary Status page
displays.
Step 4 Click the System Software tab and then click Software Upgrade. The HTTP Upgrade page displays.
Step 5 Click the TFTP Upgrade tab.
Step 6 Enter the IP address for the TFTP server in the TFTP Server field.
Step 7 Enter the file name for the access point image file (such as c1250-k9w7-tar.124-10b.JA.tar) in the Upload
New System Image Tar File field. If the file is located in a subdirectory of the TFTP server root directory,
include the relative path of the TFTP server root directory with the filename. If the file is located in the
TFTP root directory, enter only the filename.
Step 8 Click the Upload button.
Step 9 When a message displays that indicates the upgrade is complete, click OK.
For additional information click the Help icon on the Software Upgrade page.
To Next Page
Loading...
