2-30
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Removing the Access Point From the Mounting Plate
Removing the Access Point From the Mounting Plate
To remove the access point from the mounting plate when the mounting plate is attached to a surface,
follow these instructions:
Step 1 Verify the location of the mounting plate latch (see Figure 2-19).
Step 2 Push the mounting plate latch with your right index finger while gently sliding the access point to the
right with your left hand (see Figure 2-22).
Figure 2-22 Pushing the Mounting Plate Latch
Step 3
Continue sliding the access point to the right while lifting the edge of the access point with your left
hand.
Step 4 Disconnect the access point cables.
1 Mounting plate latch 2 Direction to slide the access point
ETHERNET STATUS RADIO
230562
2
1
To Next Page
Loading...
